Skip to content

FTP zones (Coggan's seven) and which FTP test to use

Coggan's seven power zones as percentages of FTP, and the three common FTP tests (20 minutes, ramp, 2 × 8) with the math behind each and who each suits.

By Updated

Functional threshold power (FTP) is the cycling cousin of threshold pace: roughly the highest power you can hold for about an hour. Andrew Coggan defined it that way so that one number could anchor everything else: training zones, workout targets and training load. Almost every structured ride you'll find, including every ride in the Fit File Forge library, is written as a percentage of it.

This guide covers Coggan's seven zones, then the three tests most riders use to find FTP, with the math behind each.

Coggan's seven zones

Coggan's training levels are percentages of FTP. Here they are for a rider with an FTP of 250 W, computed with the same function Fit File Forge uses for zones and time in zone:

Coggan % of FTP 250 W
ZoneNameRange
Z1Recovery≤ 137 W
Z2Endurance138–187 W
Z3Tempo188–224 W
Z4Threshold225–262 W
Z5VO₂max263–299 W
Z6Anaerobic300–374 W
Z7Neuromuscular≥ 375 W

In Coggan's own table:

  • Zone 1, active recovery (under 55%): spinning, easy days.
  • Zone 2, endurance (56–75%): the bulk of most riders' week. Long rides live here.
  • Zone 3, tempo (76–90%): steady, sustainable, "a bit of work". The top of it and the bottom of Zone 4 (about 88–94%) is the popular "sweet spot".
  • Zone 4, lactate threshold (91–105%): where 2 × 20s and 4 × 10s are set.
  • Zone 5, VO₂max (106–120%): 3- to 8-minute intervals.
  • Zone 6, anaerobic capacity (over 120%): efforts of 30 seconds to a few minutes.
  • Zone 7, neuromuscular: sprints. Coggan gives it no percentage, because a sprint is limited by how hard you can push, not by FTP. Like many tools, Fit File Forge draws the line between Zones 6 and 7 at 150%.

The zones overlap with heart rate zones only loosely. Power answers instantly, heart rate lags, so for anything shorter than a few minutes power is the better target. (See heart rate zones for the other ruler.)

Three ways to test FTP

All three tests estimate a one-hour number from a shorter, all-out effort, then scale it down. They differ in how long you suffer and in which riders they flatter.

The 20-minute test (× 0.95)

The classic, from Hunter Allen and Andrew Coggan. Warm up, ride a 5-minute hard effort to take the edge off your short-term capacity, recover, then ride 20 minutes as hard as you can hold evenly. FTP is 95% of your average power for the 20 minutes.

It's the closest of the three to the real thing, so it's the least flattering for riders with a big sprint. It's also the hardest to pace: most riders start too fast and fade. Ride the first five minutes at a power you're sure of, then build.

The ramp test (× 0.75 of your best minute)

Popularized by indoor training apps: the target rises by a fixed step every minute until you can't hold it. FTP is 75% of your best one-minute power in the test (TrainerRoad's method). It's short, there's no pacing to get wrong, and it's easy to repeat, which is why indoor platforms favor it.

The catch: the result depends heavily on your anaerobic capacity. Riders with a strong kick reach a higher best minute and get a generous FTP; diesel-engine time trialists get an FTP that's too low.

Two 8-minute efforts (× 0.90)

The CTS Field Test, developed by Chris Carmichael's coaching company: two all-out 8-minute efforts with 10 minutes easy between them. CTS takes 90% of the higher of the two average powers. Eight minutes is easier to pace than twenty and less dependent on sprint power than a ramp, but CTS itself notes it can overestimate FTP, and recommends it for newer riders and age-groupers.

Which test should you use?

  • Pick one and stick with it. The trend between tests matters more than the absolute number, and switching protocols adds noise.
  • For outdoor riders and time trialists: the 20-minute test. It's closest to sustained power.
  • Indoors, on an app with a ramp test: fine, but sanity-check it against a long threshold interval. If 2 × 20 at 95–100% of your ramp FTP is impossible, the ramp is flattering you.
  • New to power, or racing short events: the 2 × 8 is easier to get right the first time.
  • Retest every six to eight weeks in a build, or when workouts start to feel too easy or impossibly hard.

When Fit File Forge estimates FTP from your synced rides (rather than a number you entered), it uses the 20-minute rule: 95% of your best 20-minute power from at least three rides with power in the last 90 days. A number you enter always wins.

Your zones on your watch

Every ride in the library is written in % of FTP, and the watch works out the watts from the FTP in its own settings. That way a saved workout stays right as you get fitter: update FTP on the watch and every workout follows. Work your zones out with the training zones calculator, then try them:

Send these to your watch

Free as .FIT files from each workout's page, or send them to your Garmin from there.

Sources

  1. Hunter Allen, Andrew Coggan, Stephen McGregor. Training and Racing with a Power Meter (3rd ed.). VeloPress, 2019.
  2. Andrew Coggan. Cycling Power Zones Explained: Coggan's 7-Level System. TrainingPeaks.
  3. Hunter Allen. What is FTP?. Hunter Allen Power Blog, 2013.
  4. TrainerRoad. How to Test With the Ramp Test. TrainerRoad Support.
  5. Chris Carmichael. CTS Field Test: Why Two 8-Minute Efforts Instead of One 20-Minute Effort?. CTS (trainright.com).

Written by Caleb Wetherell; drafted with AI assistance and checked against the sources below.

Training information, not medical advice.

Want this at your paces, on your watch?

Describe it in plain words: your coach builds it at your numbers, ready to send to your Garmin.

Start free

Your coach drafts your first week free, from your Garmin training. No card.